Hello everyone,I don't remember since when but already for several
releases I have an anomaly in the list of users authenticated in wifi
through WAP2 Enterprise protocol. User authentication is provided by a
Radius server that authenticates users in ...
Hello everybody,I have a BIG problem and was start when I decide to
upgrade my 200F ( Np6 Xlite cpu )at new release 7.2.8.My scenario is a
FGT with multiple a IpSec VPN Dynamic and several SSL VPN Portal .In the
initial version 7.2.3 we had no stabil...
Hello, everyone,but is it possible to configure the HA of two FGTs when
they synchronize the configuration with a delay ?I read something about
a hw-session-sync-dev command but my two FGTs (200F) with release 7.2.3
do not have it. Has anyone ever tr...
Hello everyone,I would like to share with you this my mini guide that I
created for own purpose: block unwanted and malicious attempts to
connect to our SSL VPN permanently.Through "Automation" I created a
Stitch that get Logs of failed attempts to a...
Hello, I have a problem with disabling usernames that register on the
Captive Portal create on my FortiAuthenticator.After the registration
but before approval by an Administrator, if the user tries to
authenticate with the credentials they registere...
Hello,in the command 'dia user device list' there aren't the ipv6
address:vd root/0 be:d5:55:02:d6:0f gen 238495 req 0created 603163s gen
238333 seen 603162s WIFI_PUB_2 gen 1206ip 10.3.6.50 src arpvd root/0
42:6b:06:2b:8e:49 gen 244237 req 0created 5...
Hi Debbie,i just run the command, but list only user with IPV4 and not
IPV6..I attached the screens of my FortiAnalyzer and Fortigate when the
IPV6 has detects.When the client is authenticated, the FGT detects, in
addition to the IPV4 address which i...
Hello,the list of users with ipv6 only happens with WPA2 Enterprise wifi
and not for example with others that I manage in WPA2/3 or Captive
Portal. There must be something with the Windows AD and his NPS ( Radius
module ) . I'll also put you the scre...
I tried this command , but the default value were already disable.. To
disable IPv6 in the CLI, run the following commands: config sys
globalset gui-ipv6 disableend To disable IPv6 an on interface level
using the CLI: config sys interfaceedit config
...
