Hi all, My situation:I run SDWAN use ADVPN BGP on loopback between HQ
and 4 branches, HQ is Hub and Branches is spokes.When Branch 1 talk to
Branch 2. Spoke - Spoke tunnel is established successfully, I set up
tunnel idle timeout, and tunnel is down ...
Dear All, I have a fortigate is facing to internet, it has public IP:
a.a.a.a , port : wan 1I have IPSEC tunnel to another site using WAN 1
port also, and I have Fortimanager manage Fortigate use WAN 1 also. I
want to use Local-in-policy to block unk...
Dear Experts, I don't understant load-balacing mode and tie break option
on service configuration of SDWAN Fortigate. I think if traffic match
sdwan rule and have >= 2 paths match SLA, traffic will be load balanced
base on hash mode ? And so what is ...
Dear Expert, I am searching Fortigate SD-WAN load Balancing, and I found
2 commands:1.set load-balance-mode
[source-ip-based|weight-based|...]This command is under : config system
sdwanAnd: 2. set load-balance [enable|disable]This command under: conf...
Hello all, I am using topology for configure WCCP: But when I confiure
same guide, I can not working.so Anybody have idea or some others
command to help me ?Thank you !!!
Thanks for your reply,I dont understand, why do "The FortiGate continues
to manage traffic while ensuring that the negotiation of a new SA does
not interrupt the VPN connection ", this action make loss connection
between 2 sites . Maybe BGP can not u...
it mean, if I only apply Local-in-policy for Trusthost limit access
HTTPS, then my fortigate can not access Fortimanager and IPSEC also ,
right ?I need more policy to allow ipsec connection and Fortimanager ,
right ?
Hi @spoojary Example:I have SLA 1: Jitlter: 10ms, Latency: 10ms, Packet
loss: 2%.I have 2 paths meet SLA defined ( < SLA 1) and they are
diferent SLAs, so Fortigate will use hash mode to load balancing traffic
over these paths, right ?If 2 path have ...
