Hi, I would like to use my Fortigate hostname to login into the device
using SSH (e.g. Username@hostname). However, PuTTy gives me an error
when I try it this way. Is there a setting or command I must enable to
allow me to login in this manner?
Hi, I want to connect to my Fortigate using its hostname via SSH with
PuTTY. However, the documentation only mentions establishing a session
via IP address and whenever I try to connect by writing the hostname in
the Hostname (or IP address) field, i...
I have followed the steps from the video tutorial
https://youtu.be/YKKKlChsVVY?si=Zn7R65ElK76dbgkkHowever, despite having
followed all the steps I get the following error when trying to update
time from Internet Time Settings: An error occurred while...
I want to disable SSH Key logging completely. Also I have an ssh key
configured in my Fortigate but I am unable to delete it. I have tried
using delete, unset and setting the SSH key as an empty key but the key
does not get deleted. How may I delete ...
I understand this sounds silly but in my DNS settings I have "Use
Fortigate Servers" enabled but both the Primary and Secondary DNS
servers are listed as unreachable. However, at the bottom there is a
section which says Dynamically Obtained DNS Serve...
@Hatibi It worked by adding the hostname to the hosts file as you
mentioned above! I was able to both ping and SSH into my device using
the hostname. There was no need for me to enable DNS Server on the MGMT
interface. Thank you very much!
Hi @abarushka the Fortigate CLI reference manual, CDP is referenced for
the management-interface parameter for config switch-controller
lldp-settings. The description for the parameter states, "Primary
management interface to be advertised in LLDP an...
Thank you @sbabu but the list of protocols
(https://docs.fortinet.com/document/fortigate/6.0.0/handbook/451530/protocol-number)
which can be configured as a firewall custom service do not include CDP.
