Hi Guys, I'm trying to configure a Fortiwifi 50E and integrate it with
our standard topology.We have 7 vlans and two of them are office and
hotlan.Behind the firewall I have a switch, usually an HP or CISCO and
it's connect to the Firewall though a t...
Hi Guys, I need to switch one of my sites to VDOMs and I need to share
the WAN interface /29 between them.I've currently got a /29 on my WAN
but I've been told I need a /32 as the main IP and the /29 be routed via
the /32.Could I split the /29 an all...
Hi Guys,I'm trying to switch my national ipsec vpn site-to-site network
from static routing to ospf. Each branch's got around 6 subnets from
which only 4 should be routed via the ipsec tunnel. Using static routing
it's easy since I add only what exac...
Hi guys, I've got an existing, working fine, extended star VPN topology.
All Site-to-Site, all static IP's and quite a few subnets behind each
Fortigate box and all static routing.I have 2 questions:[ol]Once the VPN
interface is created , which can b...
Hi Folks, I have 2 FG's 70D at different locations. IPsec Site-to-Site
is configured and working fine. Along with the 70D at one of the
locations there's a Domain Controller. I've have configured an AD sync
between the FG and 70D at the same location...
Hi Tarn, I've seen this one but din't read it yet. My boxes were running
5.2.10 so I've preferred reading the old advanced routing handbook.
Upgrading my boxes to 5.4.4 is the next step. Thanks for your reply.
Cheers,Tony
Advanced Routing for FortiOS 5.2 Fortinet Technologies Inc. Page 56
"Route maps[size="2"]Route maps are a way for the FortiGate unit to
evaluate optimum routes for forwarding packets or suppressing the
routing of packets to particular destinations. C...
Hi Guys,After some struggle, I've managed to prevent the routing table
to be populated with I don't want.This is not affecting, filter, OSPF LS
updates and doesn't impact the LSDB nor the LSAs redistribution.This is
just a filter acting on the routin...
Hi Mike, I've been trying for the last few hours to use the method
mention in your link but doesn't work and has a weird behavior as
well.I'm adding an access list on router_A as follows:Router_A # show
router access-list [size="2"]config router acce...
