|
IPMAC binding can be added manually by an administrator or via DHCP.
To configure IPMAC binding, refer to the following documents:
Technical Tip: IPMAC Binding - Fortinet Community
Techincal Tip : Configure IP to MAC binding settin... - Fortinet Community
In some cases, it is necessary to delete the record of the IPMAC binding when the device has been decommissioned or the IP has to be relocated. To delete the record added manually, it can be achieved via the following command:
config firewall ipmacbinding table
delete <id>
end
On the other hand, if the record is added by DHCP, the record can be deleted by either revoking the lease of the IP or via the following command:
diag firewall ipmac delete <IP> <MAC Address>
Note:
DHCP will only automatically add the IPMAC binding entry when the command 'set ipmac enable' is set on the interface with DHCP enabled.
|
