Hi everyone How can i get a detailed hardware introduction for 1000C.I
want to know the max number of concurrent connections that the network
card can withstand and the max throughput of this machine.Recently, this
machine has been experiencing packe...
Hi every oneIs it because the first packet passes through the CPU and is
confirmed, then the third packet begins to be sent to the NPU. When the
traffic is low, it can be transmitted normally. Once more flow passes
through, the NPU cannot receive the...
device : 300C There were some packets had been lossed.I found a tip that
explain how it happed. When the the 3rd tcp handshake packet ('ack') get
handle by CPU (slow path), the 1st data would already get accelerate by
Network Processor (fast path) an...
Technical Tip: Best practice HA monitored interface configuration for
LACP interface that is used for multicast traffic. I had already seen
this tip,and my device is fortigate 3240c，v5.4.10,build1220,180821 (GA)I
created two lacp groups.port1 port2 p...
two fortigate 3240c，v5.4.10,build1220,180821 (GA)，created ha . All
config is all right. and i enable these set ha-mgmt-status enable set
ha-direct enable when i found both of them had two conflict snmp-index.
master:port27 and mgmt had the same snmp ...
Hi AEK Version: FortiGate-1000C v5.4.10,build1220,180821 (GA) Packet
lost on RJ45,there are two interfaces that are also the only ones I use.
And i am not sure if the following command can display packet loss. I
found that the packet loss was due to ...
Hi amritThe model is 1000C and the OS is v5.4.10,and my environment is
an internal network environment, did not connect internet.And the full
sessions were also small. To verify if NPU is the problem, you can
disable auto-asic offload on the policyDi...
Hi AEKThank for your advice.I will try this method. And do you know that
NPU is enabled by default? And is there any commons that will show how
much NPU used, just like get sys perfo status will show how did CPU
used. Thank you very much.
