Hello, I followed this KB
https://docs.fortinet.com/document/fortiswitch/7.0.8/devices-managed-by-fortios/801194/deploying-mclag-topologies.
This is my topology:Aggregate FGT (x1,x2) set lacp-mode active and
Fortilink split interface disable.FGT x1 -...
Hello Team, I have two FortiGate 2600F FGCP clusters (active/standby)
with FGSP enabled between them for a specific VDOM. I would like to
verify whether FGSP sessions are synchronized and see which ones are.
The following CLI commands appear to repor...
Hello team, I have configured VPN IPSec from PA to FGT but the pahse1
still down.I have enabled the debug from fortigate's CLI and following
the results: debug commands:diag debug resetdiag debug console timestamp
enablediag debug application ike -1d...
Hello Team, I connected an already configured fortigate cluster to a
Fortimanager. Now I wanted to try to create a policy from the
Fortimanager and push it to the firewall. Can you point me to the
correct procedure?To do this I saw that you have to c...
Hello Team, i have two FGT-400F.when I configure HA in A-P mode I lose
access to mgmt, or rather, I keep losing packets and sometimes I have
response but then I lose them again.HA status seems ok from cli but
secondary appears out-of-sync HA Health S...
Hello @AEK , I confirm that both interfaces x1 and x2 are connected. The
strange thing is the topology. I would expect a single MC-LAG Peer
Group, but instead I see two separate ones. Could this be because x2 is
not up? BR
Hello @AEK , sorry for the delay.When I run the command diagnose sys
session list | grep synced I also seem to see FGCP sessions. Perhaps
there are specific flags to look for in the session status, but the
official documentation does not mention them...
Hello @funkyliciousm, i don't have any policies for traffic IKE. I need
configure witch type of policy?In this way?config firewall policyedit
nset name "vpn-test"set srcintf "WAN"set dstintf "WAN"set srcaddr
"remote peer"set dstaddr "FGT peer"set act...
Hello @kaman,NGFW Mode is already selected as Profile-based.
FortiManager version --> 7.2.10FortiOS versione --> 7.2.10 I currently
have a fortigate 6.4 connected to FortiManagere with a policy package
assigned but even here I have the “new” button d...
Hello, unconfigure HA then execute factoryreset on the secondary member
and then reconfigure HA and all work as expected. Thanks to all for the
supportBR
