Hi, I would want to ask a question on the issue that was raised
earlier.I have two wan lines, I have set up both tunnels on WAN1 I'm not
sure if his setup is accurate. Should one tunnel be installed in Wan 1
and the other tunnel in Wan 2? Still, I ha...
Hi thereI'm not able to access via DydNS I notice that the DNS is green
and that the public IP address is okay. I am connecting through DHCP and
receiving a private IP address of 192.168.100.10 from the DNS WAN
provider enable https .Why am not I abl...
How am I able to access switches and https (faz..) through bookmark and
i cannot access through vpn ssl I checked the policy and it's fine, but
could be a proxy for whatever in the middle?
The goal is to pass vlan 8 and vlan 40 MGMNT without tagging. how i can
do it?The configuration inside internal port 1, but my suggestion is to
be able to use vlan 40, similar to native mgmnt ap, and the vlan 8 pass
for the trunk as well.Vlan 8 is cu...
I would want to express my gratitude for your assistance. @amrit
@DPadula The problem was resolved. The AWS route database needed to be
cleaned, and then the ping succeeded.
I neglected to mention that the client uses Fortiswitch.for your
consideration This time, the aws guy had to ping from this
server10.40.6.58 FortiGate1 # diagnose sniffer packet any 'host 10.0.0.5
and icmp ' 4 0interfaces=[any]filters=[host 10.0.0.5 ...
I guess it is directly I was working with an AWS person on a tester. He
assured me that his perspective is accurate, but I'm not sure how he can
present it clearly.
Yes it is correct from 10.0.0.5 server lan citrix no ping to 10.40.6.119
server aws . From 10.40.6.119 to 10.0.0.5 ping is ok I attach you the
test FortiGate1 # diagnose debug flow filter saddr 10.0.0.5FortiGate1 #
diagnose debug flow filter daddr 10...
