Description This article describes how to use the CLI console to change
the FortiCloud account linked to the FortiGate. Scope FortiGate.
Solution This method is useful when the incorrect FortiCloud account was
used in the FortiGate, instead of the ac...
Description This article describes how to use the CLI and the GUI to
review the IPv6 routing table Scope FortiGate v7.4 Solution CLI. To
review the IPV6 routing table the below commands can be used: get router
info6 routing-table Additionally, the be...
Description This article describes how to use the built-in Wireshark
packet capture functionality to capture DHCP Traffic. Scope FortiGate.
Solution In certain scenarios, capturing DHCP traffic can be helpful for
troubleshooting. Packet capture in Wi...
Description This article describes how to use the clone reverse feature
to optimize the Firewall policy creation and configuration. Scope
FortiGate v7.2.x, v7.4.x. Solution To streamline Firewall Policy
configuration, it is possible to clone an exist...
Description This article describes how to resolve SSL VPN authentication
errors that occur before completing the DUO 2FA push. Scope FortiClient,
DUO. Solution When using DUO with FortiClient, the VPN authentication
might fail before the end user com...
Found some documentation about it but using the FortiGate in combination
with a FortiSwitch or FortiAPs. See below:Dynamic VLAN 'Name' Assignment
from RADIUS Attribute VLAN assignment by RADIUS | FortiAP / FortiWiFi
7.6.0
FortiGate reads the policies from top to bottom in the Firewall Policy
list. Make sure the new policy allowing access to the new Web Server is
above the GeoBlock policy.
Hi Lucas, sometimes is necessary to configure an IP address in the Ipsec
tunnel interfaces for this configuration to work. See the KB below:
Technical Tip: Configure automation backup over IPsec tunnel
