Having an issue I can't figure out and want to see if anyone else has
experienced this same issue. I am trying to create an ldap profile in
FortiManager to test using OU groups or specific users in firewall
policies. Current version of FMG and FGT ar...
This may be too broad of a question, but will ask in the event some
replies or questions may provide any guidance at all. We just ordered
FortiPAM, but am struggling on placement of the device based on the
design documentation as per this link
https:...
Hey all - running into an issue deleting an address object that was used
in an IPSEC configuration. I was able to delete the tunnel completely
successfully, but as last part of clean up was to remove the address
object I created to reference in the t...
I have a strange issue with FortiManager, I have two sites that have
radius configured for VPN authentication. Each site has a local server
and a remote server as a backup that connects over IPSEC. I set a source
IP in FortiManager and push the syste...
I appreciate the reply, but looks like there are methods to set it up
without public access, which is what I prefer to do. I forgot to include
that in the original post. Just failing to find the correct
documentation. I may have to contact our SE for...
@smkml @Toshi_Esumi Thank you both for your replies. In this instance,
smkml was spot on. It never dawned on me that the issue would be a
device mapping that was overriding the config. I did not manually create
the mapping but it was obviously create...
Was finally able to figure this out. The debug I was running was only
capturing traffic allowed in the tunnel. After doing a sniffer on the
IPSEC interface, I found that the log settings to send syslog to a
server on the other end did not have a sour...
