I need help with configuring redundant IPsec tunnels. The peer firewall
has 2 public IP addresses. When the primary ISP is offline, the firewall
routes everything through the backup ISP, which is working fine so far.
On our Fortigate, I have configur...
I found the following article about ospf inter-area
Since I come frome cisco, the way I have to configure NAT in Fortigate
is new to me. I have a working configuration but some settings don't
make sense to me... public ip range: 188.8.131.52/27Fortigate public ip:
184.108.40.206dmz interface: 10.9.11.1/24webser...
I configured a ikev1 tunnel between Cisco IOS and Fortigate.The tunnel
comes up but communication only works after a client of the remote site
(cisco) initiated some traffic.As you can see in the Fortigate capture,
the packet to 10.183.2.1 is sent in...
Thanks Manosh, that helped a lot. After configuring the "set monitor
"isp01" in the phase1-interface of isp02 I still had the same issue. I
also had to change the DPD "on-idle" instead of "On Demand" and now it
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.