Description This article describes how to enable
forticlient-on-net-status on the FortiGate interface. Scope FortiGate.
Solution Go under Network-> Interface, choose the desired interface to
edit, Toggle the' DHCP Server ' option if not enabled, and ...
Description This article explains the steps to check the log storage and
capacity of the FortiGate. Scope FortiGate. Solution Go to the Log &
Report tab -> Settings -> Local logs. The available storage space on the
FortiGate 61F serves as an example,...
Description This article describes scenarios if there is a requirement
to forward internet traffic for a specific subnet over an IPsec remote
tunnel. Scope FortiGate. Solution Step 1:It is necessary to create the
site-to-site VPN tunnel between two s...
Description This article describes how to resolve the 'error -651:
Input' value is invalid when creating a firewall policy for an SSL VPN
interface. Scope FortiGate. Solution There would be scenarios before the
deployment of the firewall onsite where...
Description This article describes how to sync out-of-sync HA devices
after a firmware upgrade due to firewall.internet-service-name. Scope
FortiGate. Solution After upgrading FortiGate HA, there are a few
scenarios in which the secondary HA device i...
Hello @damianhlozano , Thank you for contacting the Fortinet Forum
portal. -In the event logs it shows only the switch of sla members and
for additional logs, you can enable a few settings to verify, You can
verify and monitor from sla packet loss on...
Hello @jbivens , Thank you for contacting the Fortinet Forum portal. Can
you try checking under the advanced settings and verify if you have any
option to limit the login attempts: Creating SSL VPNs | FortiManager
7.4.1 | Fortinet Document Library -I...
The command that I provided earlier will record all the configuration
changes on the GUI but unfortunately, it doesn't give any option to cut
the text we just have to remove the extra information which we don't
need after downloading the console log,...
Hello @IrbkOrrum , Thank you for contacting the Fortinet Forum portal.
Please refer to the article below which shows what changes are being
made on GUI will be showing as cli configuration the
https://community.fortinet.com/t5/FortiGate/Technical-Tip...
Hello @Ganbayar , Thank you for contacting the Fortinet Forum portal.
After verifying the steps suggested by @FortiArt and @AEH make sure to
enable the "set match-vip enable" firewall policy if you have any
Virtual IP configured refer to below articl...
