Description This article explains how FortiSASE pushes upgrade
notifications to the FortiClients in various scenarios. Scope FortiSASE,
FortiClient. Solution FortiSASE Cloud has its own set of 'FortiClient'
software as compared to what is present on ...
Description This article describes the solution to a case where, when
installing the TS Agent on the Citrix server, it displays the error
message below if the 'System Dynamic Allocation Port Range' (which is OS
dependent and can vary) overlaps with t...
Description This article provides an explanation of the IKE debug error
message of 'established IKE SA limit 4 reached, deleting '. The
repercussion of this error message is that the IPsec tunnel will be
flapping continuously despite Phase 1 and 2 UP...
Description This article describes how to advertise the SSL VPN pool
over BGP. Topology:FGT-HO-----Internet-----FGT-BO. FGT-HO has SSL VPN
clients connected to it using the pool of 15.0.0.0/24 subnet, and it is
required to advertise that pool over BG...
Description This article describes that, when the below command is
executed, it provides the necessary debugs, and the error message is as
follows. It will fetch the ACME client's full status log for a given CN
domain. It will show the below error me...
Hello, The website forticare.fortinet.com is certainly reachable, and is
required to verify the license from FortiGuard. Alternatively, you can
check below document and see if it helps. Procedure to apply FortiGate
firewall lic... - Fortinet Communit...
Hello @it-andreagx , I believe the configuration looks fine, but make
sure that the destination address in the traffic shaping policy is the
VIP object which can perform DNAT for the ingress traffic from the
internet to the internal server. To confir...
Hello @ahmadmasalmeh , You might need to perform the dialup
configuration on FortiGate so that it acts as a responder and the
TP-Link router as the initiator. In this config, FortiGate will be
listening for IKE negotiations from any device that has t...
Hello @Tauriq , If the issue is site-specific, and everything else works
fine while being connected to specific APs, then it's best to take
wireshark capture on the user device, ingress interface, and egress
interface of the FortiGate. Then, look for...
Hello Tauriq, If you are facing client connectivity issues over the
wireless, then you may check for the below reasons that could cause
this. If the client is unable to connect to FortiAP:Make sure the client
security and authentication settings matc...
