Hello All, Need to manage 2 FGT in my organisation running as
Active-standby mode with their dedicated management port (MGT 1 or MGT
2). Is it possible to manage them individually with different ip address
like 172.16.20.1/24 to MGT 1 Port of Primary...
Hello All, I have two Fortigate devices 1100D in my premises running
Active-Passive mode using two port as HA links and one lan and wan link
on each devices. Basically I need to move these devices from one
building to another. Need to know what are t...
Hello All, Need to restore backup from FGT 1100D running 6.6.4 version
to vm series . Can anyone please help me can I just dump backup from FGT
1100D to vm series directly ? .if not then what are the precautions I
need to take.
Hello All, I have 2 FGT in A-P Mode running in my organisation connected
to two MPLS router (interconnected with trunk link) as outside and two
core switches (in Stack) as inside zone. Please refer the attached
diagram. Basically i want to achieve re...
I'm using pre-defined physical Management port comes with device named
as Management not any normal data port for management reservation. Would
be possible to take dedicated device management from dedicated
management port or need to use/define port ...
Thanks Toshi, I have assigned dedicated mgmt 1 Port of both active and
primary units but unable to access secondary device from mgmt 1 Port.
Also I have observed one thing that when I change my secondary device
mgmt 1 Port to ip address 192.168.1.101...
Hello Jorge, Are you talking about these lines
#conf_file_ver=330600812719265 #buildno=0268 If yes then do I need to
replace both config-version and conf_file_ver from config ...