Fortinet Community

aahmadzada · 04-17-2023

Description This article describes how to configure web mode SSL VPN to follow the SD WAN rules when it comes to the selection of the proper egress interface in order to reach the destination. Scope FortiGate. Solution Starting from FortiOS 6.2.6 and...

aahmadzada · 11-15-2022

Description This article describes that the application control detects the application type, but does not block it if the FQDN is in the exempt list of the deep inspection profile. Scope FortiOS. Solution If an FQDN (for example sls.update.microsoft...

aahmadzada · 11-08-2022

Description This article describes the configuration steps necessary to apply FSSO rules to SSLVPN users. Scope FortiOS 7.0 and newer versions. Solution FSSO rules can be used for the traffic generated by remote access VPN users. In order to have a p...

aahmadzada · 10-06-2022

Description This article covers the configuration of two DNS servers along with the captive portal on two different interfaces of FortiGate. Scope FortiOS 7.0.6 and newer versions. Solution On FortiOS versions prior to 7.0.6, it was possible to confi...

aahmadzada · 10-06-2022

Description This article describes the improvement, which was implemented and allows the configuration of multiple addresses for the authentication portal. Scope FortiOS 7.0.6 and newer versions. Solution Previous versions of the FortiOS did not allo...

aahmadzada · 05-23-2023

Good day Yurisk,When it comes to the Admin Guides and etc., please follow up with the Grahams suggestion.When it comes to that specific KB article, I believe there is a typo and I have submitted the correction. Thank you for pointing out this. Ahmad

aahmadzada · 05-18-2023

Hi, This KB could be a good start point in troubleshooting: https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-IPsec-VPNs-tunnels/ta-p/195955

aahmadzada · 05-18-2023

This might be due to mismatching settings on the Fortigate and FSSO collector.Can you please:1. Make a screenshot of the fsso connector settings on the Fortigate2. On the Collector Agent (CA) open the Fortinet Single Sign On Agent Configuration conso...

aahmadzada · 05-15-2023

Hi, With the current design of FortiOS L2tp dialup VPN is able to assign IP addresses only and only from the configured IP address range. Ahmad

aahmadzada · 05-15-2023

Maybe you have vdoms? In that case yo should run these commands under a certain vdom. Ahmad

Fortinet Community

User Statistics

User Activity

Technical Tip: Web mode SSL VPN supports SD WAN rules

Technical Tip: Application control detects the application type, but does not block it if the FQDN is in the exempt list of the deep inspection profile

Technical TIp: Configure Fortinet Single Sign On (FSSO) for SSLVPN users via Syslog

Technical Tip: FortiGate configured with multiple captive portals and as a DNS server

Technical Tip: Multiple addresses for the authentication portal

Re: Is there a way to make feedback on the official documentation?

Re: Fortigate PPPoe (Ipsec Vpn )

Re: FSSO user verified but internet is not working

Re: FortiGate L2TP/IPsec with RADIUS authentication and Framed-IP-Address

Re: MFA Timeout settings for third party authenticator

Re: Non-FortiLink interfaces should not have multi...

Re: FortiGate L2TP/IPsec with RADIUS authenticatio...

Re: VLAN/DHCP over Site to site VPN

Re: Fortigate 60D ISP speed limit

Re: FortiOS explicit Proxy Kerberos Authentication...

Re: FortiGate L2TP/IPsec with RADIUS authenticatio...

Re: FortiSwitch - Configuring multiple SYSLOG serv...

Re: FortiGate 200D - Log Disk issue on HA2

Re: forticlient SSO android app changes the user

Re: FortiClient does not have "Push" option when u...