Technical Tip: FortiAnalyzer HA Configuration and ...

mkannan · 08-04-2022

Description This article describes how to configure and troubleshoot issues with FortiAnalyzer HA. Scope FortiAnalyzer. Solution Pre-request: A Layer-2 connection between Primary-FortiAnalyzer and Secondary-FortiAnalyzer is mandatory to communicate t...

mkannan · 11-28-2018

Description This article explains how to add new disks on FortiManager or FortiAnalyzer instances in Microsoft Azure. Scope FortiAnalyzer and FortiManager, Microsoft Azure. Solution The steps are identical for both FortiManager and FortiAnalyzer. Thi...

mkannan · 11-28-2018

DescriptionThis article describes how to increase the number of rows in a VPN report for a specific chart.SolutionIn FortiAnalzyer reports, pre-defined charts often are limited to display the top 10/20/etc results.It can be desirable to see more than...

mkannan · 02-07-2018

DescriptionThis article explains how to handle the message on “Switching to RO mode” on FortiPortal.ScopeFortiPortal v4.0.0 and aboveSolutionThe error message on FortiPortal as “Switching to RO mode” is seen on FortiPortal as shown in the following s...

mkannan · 02-07-2018

DescriptionThis article explains how to filter multiple IP addresses and entire subnet.ScopeSolutionOn the FortiAnalyzer: - Go to Reports > All Reports > Bandwidth and Applications Report. - Add Filter - Specify Log Field. In this example Destination...

User Statistics

User Activity

Technical Tip: FortiAnalyzer HA Configuration and Troubleshooting

Technical Tip: Adding new disks on FortiManager and FortiAnalyzer instances in Microsoft Azure

Technical Tip: How to change number of results in FortiAnalyzer Charts

Technical Note: Switching to RO mode

Technical Note: FortiAnalyzer bandwidth report to filter entire subnet and single IP

Technical Tip: FortiAnalyzer HA Configuration and ...

Technical Tip: How to connect a FortiWeb to a Fort...

Technical Tip: Management IP for Fortinet VM produ...

Fortinet Training Institute

KCS