Hello, I'm using OS 5.4 on a 100D and the documentation / video support
is somewhat vague when it comes to the WAN LLB configuration. What I am
trying to achieve is basically setup a failover WAN connection, WAN1 as
primary and WAN2 as secondary.It a...
Hello, I keep bouncing between using VDOMs or Policies to accomplish my
end goals. My concerns are;LAN traffic interfering with VoIP servicesWAN
failover functionalityVPN (IPSec/SSL) load on interfaceTraffic routing
and shaping One suggestion is to s...
Hello, High level, I have a 100D running OS 5.4, 2 ISPs with multiple
public static IPs.WAN 1 and WAN 2 are setup in WLLB so traffic uses WAN1
with Failover to WAN2. I have configured 2 Hardware Switches grouping
ports 1-8 for LAN and ports 9-12 for ...
Hello, I'm trying to configure a Routing Policy that takes traffic from
an interface and forwards through a specified interface. My question is,
how do you find the values to set in the Type of Service Bit Pattern and
Bit Mask? I could be wrong but I...
Hello, I am switching from really old Watchguard firewalls to an new
Fortigate platform across my company. I have a question about
recommendations for a 100D configuration. My past setup I ran two
separate physical firewalls, one for LAN and the othe...
Thank you for your reply. In option 1, I understand that interfaces can
only be assigned to 1 VDOM. The issue that is making me consider this
option is that you can't assign IP addresses on the same subnet to an
additional interface. For example, WAN...
I'm new to Fortinet products and thus not really an expert but my first
question is did you also configure a reverse policy? A policy that
allows PORT1 to pass traffic back to Office Network?
I guess my main concern is putting too much load on 1 interface. Setting
up additional WAN interfaces could offload and increase traffic
performance, security and redundancy. I'm already using the WLLB for
failover between my 2 ISP and I have a WLLB ...
