Hi All, I have configured a redundant site to site IPSEC VPN between 2
FGT E units, both running 6.0.6. Basically, setup is as follows: Tunnel
1 - Site A ISP1 to Site B ISP1Tunnel 2 - Site A ISP2 to site B ISP1 To
allow failover, administrative dista...
Hello all, I'm trying to setup remote access for offsite clients without
use of the Forticlient (We were mandated to use the built-in
Android/IOS/Windows PC default clients). I am trying this on both a
Fortigate 50E and 60E and 5.4.3 and 5.4.4 I've n...
Hello All, I am currently trying to configure redundant IPSEC Tunnels
between 2 Fortigate Units (a 60E and a 50E), with each site having 2
ISPs each. While I have successfully configured the redundant tunnels,
the times between failovers are very lon...
Thank you for the info! I knew I just read somewhere that on-idle was
default :| Yes, I can confirm - set retrycount to 2 and the number
changed. I just didn't bother trying this since an old config listed the
dpd-retrycount to 3 and was clearly show...
Thanks. What would you have any recommended values for these two
variables? If it would help in your recommendation, the internet can be
a little spotty in my country, which is why I am doing this to begin
with.
Hi neonbit. Thanks for this info. Will try tomorrow. In my limited
experience & understanding, this seems to be the answer I am looking
for. Will update this thread again. Many thanks for your help! :)
