Dear Mahmoud, You can not control the APs with fortigate.But you can
connect these AP's to the fortigate interface and control the users. The
same authenticationas you would do on utp ports. Regards,
Dear Sears, You configure al AP's in bridge mode.Use a layer-2 switch to
interconnect all AP'
shttp://cookbook.fortinet.com/setting-up-a-wifi-bridge-fortiap/ regards,
Hi Viktormmh, Did you configured 2 policies on both sites ? (NO Nat)If
yes, do a sniffer at 60E to see if your ping_request is entering the
tunneldiag sniff packet "host "
regards.
Hi Obi, If am not wrong, you cannot do this.If your Fortigate is in
Nat/router mode, there is a switch between al ports in Internal.Firewall
policies only work if packes are routed.I propose to make separate
subnets. gr,go4it
