Hi,I’m encountering a reachability issue between our Head Office and
Branch Office following changes to our IP Sec VPN setup.Specifically,
the public IP of our Branch Office b-b-b-b is no longer reachable from
our Head Office IP h-h-h-h. However, b-b...
Hi, Please help me using my fortigate 100D as aggregate switch just as
we do in Cisco layer 2 switch as below : interface GigabitEthernet1/0/33
switchport trunk native vlan 400 switchport trunk allowed vlan 2,3,400
switchport mode trunk switchport no...
Hi, Need urgent attention with an issue related to trunking aggregated
ports in criss-cross HA environment. I am sharing below configs from
cisco c2960 switch1 and cisco c2960 switch 2 with on the firewall
fortigate 400E with ports 9,10,11,12 in 802....
Dear All,I am using FGT400E and I am facing issue with an application
named "Tally" which is used for accounting purpose. This application
server is installed on a server with IP : 192.168.1.2/24 Port 9999 and
working fine in the same network [VLAN 1...
Hi,Pfa an elaborated network diagram. Firewall FGT100D at Site 2 act as
a router only. FGT600c at Site 1 Headoffice side has been used for
firewall permissions with different policies created for Site_2. Now the
issue is with the routing that when we...
Hi, Thanks Team. I had found that a blackhole static route was created
by the automated ipsec tunnel creation earlier, and due to that only the
b.b.b.b was not reachable and it works after deletion. Thanksa lot.
Hi, try to connect vpn through tunnel mode and try to usemstsc.exe
-multimon reference :
https://support.steadfast.net/knowledgebase/article/View/107/3/using-multiple-monitors-with-windows-remote-desktop
See if it helps. ThanksRohit
Hi,Thanks for the replies.These are in standalone presently and I have
to stack them. Just finding way out if it feasible to stack in
C2960XR-48TS-I. Regards,Rohit
Hi, It can be stopped from application control. You can make 2 policies
which will be clone but with 2 different schedule(Night and day) and
allow or deny updates as desired but through application control. This
is what we do ThanksRohit k