i would like to interface it with Exchange 2019 and Vmware Horizon with
many different AD servers.also we need mobile push auth feature with
Fortiauthenticator Can anyone know process to configure it , i will be
very helpful if any one help on thisRe...
Dear Team , In our environment we are going to deploy Cisco Expressway
and E setup with Single NIC So i want below NAT translation Can you
please help us to write rule for below requirement . Source Original
Destination Original Source Translated Des...
As you mentioned in post that you dont have switch for ISP Connectivity
You should connect both ISP in Primary Firewall and then you can use ISP
load sharing Method and use both ISP Once your primary Firewall will
goes down you should manually connec...
Dear , How you configured Cisco Switch - is in stack or standalone mode
? If you have configured cisco switch as stack then it will be good to
go with this setup.Regards,Harmesh YadavCCNP CCSE
Dear Team , I also face this problem in one of client end . find below
mentioned linke that settings should be default in Fortigate Firmware
https://kb.fortinet.com/kb/documentLink.do?externalID=FD40914 ALso For
ALG settings find below procidure to d...
Dear , You have to create one Network Group and Add all IP on it and
block by creating firewall policy . If you need to block Geo location
also you can add multiple Geo location in Policy and block it .
I would suggest to do first analysis of all rule of ASA and then please
do migrate to fortigate firewall configuration and do additional
security top of it . If you need help you can reply on this same post
