Hi, I have activated the Central NAT Table on a Fortigate 100D with
firmware 5.4. Now when I create a policy and enable the NAT I can't
select the IP Pool. Fortinet has inserted some change about central nat
table and IP Pool on new fortiOS 5.4? For ...
Hi,what is the default action if the traffic that flow through the
Central NAT table doesn't match any rule? In my test, if in the policy
is enable NAT with flag " Central NAT Table" and the network traffic
that pass through it doesn't match any rule...
Hi,I am new to the Foritgate systems. We just purchased a 92D that
replaced a old Check Point firewall. I want to translate the policy and
nat configuration from Check Point to Fortigate. What is the best way to
write this Nat rules on Fortigate? <--...
Hi, I have the same problem after upgrade the my Fortigate 100D to
FortiOs 5.4. I have made a downgrade to the previous firmware version to
resolved the problem. In this days I doing some test in my lab with
FortiOs 5.4 and I notice that with this re...
Thank you for the quick reply. Infact, for the fifth rule I created this
VIP with "set protocol icmp": edit "VIP_ICMP" set extip 2.2.2.2 set
extintf "any" set portforward enable set mappedip "3.3.3.3" set protocol
icmp next I don't think that implici...
Yes, I used this workaround . But you must consider that in my example I
used "service=any" that it means all protocols (tcp , udp and icmp). In
your declaration you use only tcp protocol. If you want to consider all
protocols I think that you must d...
