You will need to define an Application Control policy and a traffic
shaper. Apply the shaper to the desired Applications, then apply the
Application Control Policy to the desired ipv4(6) policy.
"List resources" is only going to check for a preset list of generic
MIBs (Volumes, Interfaces, Routing Table, etc) Since a policy-based VPN
does not have an interface, you will need to create a universal device
poller to poll the MIB for the phase 2...
Do you have a route for your Carrier's SBC (or whatever IP you register
to) that points to the gateway on WAN2? You can set up a packet capture
on the 60D by going to this hidden
pagehttp:///p/firewall/sniffer/ Sniff on the WAN2
interface and try to ...
Make sure you have a default route. If it does not have a default route,
it will send an ICMP No Route To Host msg. That will not reach the
policy since the packet does not get forwarded due to no route. You
might also want to enable NAT in your poli...
