I have a Fortigate 100D and several 60D all running 5.2.2 that all need
updating to possibly 5.4.4. Does anyone know if I will run into issues
with IPSec VPN's or anything if I update them 1 at a time. I plan to do
them as I travel to these locations...
This is not my strongest area but it is the its the task at hand..Main
office 100D v5.2.2Branch 60D v5.2.2Followed instructions from video to
create a site to site. Went to VPN/Monitor/IPSec Monitor and it shows
the status as down. Any guidance would...
Thank you for your quick response. I would do them remotely but when I
did that last time, it cleared out one of the settings and left that
branch dead until I was able to get out there.
I did use the FGT-FGT template. Ran the commands suggested by ede_pfau
and see that its trying to use my modems provided subnet which does not
match what the fortigate gives out. Assuming I need to bridge the modem.
https://www.youtube.com/watch?v=sZC0AldHi34 I have been going through
them line by line and look identical. After completing the wizard, the
phase 2 selectors were all zeros. I've manually set them to the correct
addresses and it made no difference.
