Good morning. Trying to clear these input and output port stats for a
FortiSwitch running v6.4.x Any suggestions?Port(port13) is Admin up,
line protocol is upInterface Type is 10 Gigabit SerDes Framer Interface
(SFI)Address is 04:D5:90:E9:FB:32, None...
You used to be able to sort columns on the web interface (pretty much
any screen that has columns) by right clicking on the column and
dragging the items around to the order you want. It seems somewhere
along the line they either removed it or someho...
Whats the procedure like for changing a Fortiswitch from a standalone to
one that's managed by a Fortigate? I have 3 Fortiswitches in production
that are working as expected and would like to have them managed by our
Fortigate cluster however I don't...
Is there anything special I need to do for IPv6 multicast on the
FortiSwitches? We're getting some new equipment (Nutanix HCI) and the
network requirements are "Make sure IPv6 is enabled on the network and
IPv6 multicast is supported."
Stupid question that I've been beating my head against. My new FS (1048E
running v6.4.2) has a dedicated mgmt interface but I don't want to use
it and would rather have mgmt allowed on any interface that is
up/connected to the network and essentially...
all is working as normal. Not sure if it was the media converter or
something else. Interesting to note that the 1048E worked with just
applying the IP address (in this case 172.16.1.50) to the "internal"
interface and allowing access protocols. The ...
SecurityPlus wrote: Have you been able to resolve this issue yet. No,
not yet. I ordered a replacement fiber to copper converter and it should
be getting here today. I connect it to port 1 on the 1048e and make the
config changes and see what happens...