Hi, I have problems with creating a Site-to-site between a 60E(behind
nat/router and a old Juniper FW. The fortigate is claiming the tunnell
is up and the same about the juniper, but no traffic is passing last log
entry on juniper:IKE 85.x.x.x Phase ...
se attached picture. I'am trying to port forward some traffic via WAN2
as a backup via 4G modem - but it dont seems to work. When connecting my
computer directly to the 4G modem with same IP adress as the WAN2
fortigate, port forwarding on the 4G i w...
i really dont understand a thing. I've been pinging between these two
sites all day. To traffic passing. I've just sat down with this, logged
into web gui of the juniper to check firewall logs, and then SSH into
juniper for testing some "get" command...
No FW rule changes on the juniper is done.. the tunnel went ut passed
traffic.. the day after, no traffic (but tunnel is still up). I'll check
out the firewall on the juniper. on the other hand - why wont this
command work on the FGT? diag debug flow...
a little follow up on this. the tunnel is suddly not passing traffic..
When i try to do a sniffing this is the result: # diag sniffer packet
Metro interfaces=[Metro] filters=[none] pcap_lookupnet: Metro: no IPv4
address assigned 16.764178 192.168.22....
