Description In a multi-VDOM, FortiGate SNMP will be mostly used on an
interface that is part of the management VDOM. Anyway, it is also
possible to query an interface, that is not part of the management
interface. This article explains how. Scope For...
Description This article describes how to disable 'Migrate Config with
FortiConverter' in FortiGate Setup. Scope FortiOS 7.4.0 and above.
Solution During the 'Migrate Config with FortiConverter' setup, one
usually has the option to toggle the 'Don't ...
Description This article describes that the cluster may show out of sync
in 'application.list' after an upgrade and how to fix it. Scope
FortiGate cluster after upgrade to v7.2.x. Solution Log into both
cluster units, and enter the following commands...
Description This articles explains how to set up a management IP without
a dedicated HA management interface. Scope Any FortiGate cluster.
Solution With an HA management interface (see this article for more
information), cluster devices can be querie...
Description This article describes the differences between 'debugzone'
and 'checksum' in an HA cluster. Scope FortiGate ha cluster Solution The
checksum of cluster units can be viewed with the following command: #
diag sys ha checksum cluster =======...
hi kaplan. from your screenshot, can you just switch the button "Enable
NTP Server" so that it will be disabled from FortiManager? then push the
config over to the FortiGate, wait until it is finished, then delete the
fortilink from FortiManager and ...
hi there.sorry, just found this post while searching fomething
different.anyway, if still do not know yet, here is theanswer:
https://docs.fortinet.com/document/fortigate/6.4.0/new-features/592847/ip-definitions-database-merged-into-the-internet-serv...
maybe it is this, what you are looking for? forceIf you have enabled
override, you can disable pingserver-slave-force-reset to reduce the
number of failovers. If override is enabled and a remote link failover
has occured, after the flip timeout, even...