Hi guys, Recently the management was inaccessible but it could be
pinged. After a reboot the device was accessible again and all was well.
Is there anything I could run/see that could help me identify what
happened around the time of the incident? Re...
Currently the school is out due to holidays, but I can still see
connections being active. Can someone confirm that these may just be
devices idling that are still connected to the Internet. Kind
regardsMiata
Hi guys So my FG-60D running 5.2.3 has been at 100% CPU and about 90%
memory recently so I thought I would run the diag sys top command as
shown below. From this command I can see that the scanunitd and IPS
engine it taking most of my CPU usage. I do...
Hi guys I am unable to use Teamviewer as it's just giving us a message
saying that I have no internet connection. I am using the Fortigate 60c
on 5.0.5. Any ideas why this might be happening? CheersMiata
We have a fortinet firewall: FortiGate 311B Firmware Version
v5.2.3,build670 (GA) [Update] We are working in NAT configuration Poort
1 is used for management. Poort 2 is uplink to outside world The other
ports are aggregated in one pipe with each of ...
Thanks for your replies. Yes the computers are constantly on, so that
would make sense. It's only small amount of data being generated too, so
there's nothing too strenuous which backs up your point of them finding
updates etc. Is there anything I ca...
Well I think that generally I'm over working the box, as it is only a
60D. These boxes can't really take a lot of tasks, especially if one of
them is to scan every bit of traffic that comes in and out of the box,
as well as a bunch of other tasks whi...
Hi Thanks for the comment. My mistake, this is just an example of the
diag sys top command, there are many others that show it fluctuates
between the given value and 90%+. Miata
