Hi, I have setup a s2s routed based vpn with BGP on it and this s2s vpn
is established. I can ping the other side which is 192.168.1.1 and my
side is 172.23.0.1. But I have this strange situation which might lead
to a bug (I think): Firmware of the F...
Hi guys, I would like to know why I cannot set my security profiles on
my security policies... I cannot found why or how to solve it. When I
set a security profile like anti virus or web filter or application
control or ips (default or new created on...
Hi Toshi, Actually I do not use an IP on the neighbor basically my
tunnel has no IP address. Normally you don't need this for routed s2s
vpn (for ospf or bgp), with other vendors like PA or Checkpoint work
like without any problem. FYI:I've also conf...
Hi Benoit, I've already done this ;) FW_A_001 (bgp) # show config router
bgp set as 6000 set router-id 172.23.0.1 config neighbor edit
"192.168.1.1" set ebgp-enforce-multihop enable set interface "port2" set
remote-as 65011 set route-map-in "rm-AZURE...
Hi Ken,My customer asked me to verify this, so I need to know in which
version this could be fixed.I assume this is a bug as well, but there is
no verification found in known resolved or bugs..
@boneyard, I found the solution which was creating my own firewall
profile-protocol-options and applying this to all my security profiles
which was ok Solution steps are these below: FGT40C# config firewall
profile-protocol-options FGT40C(profile-pro...
