Re: FortiWeb denies some uploaded files

Pedro_FTNT · 10-27-2025

Description This article describes that Sniffer shows no live packets, but the counter increases on stopped. Scope FortiGate. Solution On the source FortiGate, approximately 1000 packets are captured using a host A ↔ host B filter.On the destination ...

Pedro_FTNT · 08-28-2025

Description This article describes ports' behavior in IKE negotiation, IPsec/IKE Negotiation Ports (with and without NAT-Traversal). Scope FortiGate. Solution Ports Used in IKE/IPsec. Without NAT-T (no NAT detected): IKE Phase 1 and Phase 2 negotiati...

Pedro_FTNT · 07-28-2025

Description This article describes how to understand the full options displayed by the 'diagnose netlink interface list' command. Scope FortiGate. Solution Diagnose command: diagnose netlink interface list port This command a diagnostic tool used to ...

Pedro_FTNT · 07-27-2025

Description This article describes how to guarantee that all elastic IP addresses (primary and secondary) migrate correctly when a failover is performed on a FortiGate cluster in AWS. Scope FortiGate. Solution Introduction: FortiGate SDN Connector (s...

Pedro_FTNT · 04-29-2025

Description This article explain what is the different between 'TX dropped' and 'Host Tx dropped'. Scope FortiGate. Solution Using the diagnose command: fnsysctl ifconfig Example: fnsysctl ifconfig internal6 internal6 Link encap:Ethernet HWaddr 00:0...

Pedro_FTNT · 01-15-2025

Hi, thanks, we could do a remote session to reproduce the issue and take, debugs, logs... :)

Pedro_FTNT · 01-14-2025

Hi, do you have the logs ? Its possible reproduce ?? we need to take some captures also I could ask to dev team with information taken :)

User Statistics

User Activity

Technical Tip: Sniffer shows no live packets, but counter increases on stop

Technical Tip: Understanding IKE negotiation ports 500/4500

Technical Tip: Understanding 'diagnose netlink interface list' full options

Technical Tip: How to guarantee that all elastic IP addresses (primary and secondary) migrate correctly when a failover is performed on a FortiGate cluster in AWS.

Troubleshooting Tip: Understanding the difference between 'TX dropped' and 'Host Tx dropped'