Hi All,do somebody already configured VPN tunnel for windows 10 Native
VPN using the IKE tunnel Type. i have first set up a vpn using a wizard
for L2TP connection, everything seems to be OK, but the problem with
this setup is that we only have one L2...
Hi,do somebody already szetup a link agregation with 2 wan ports to
Cisco 2960-X and it worked correctly on Fortigate 200E? here is the
story :) we have a 200E freshly installed and we've created an interface
vlan on with no problem for interconectio...
we have a 300E a-p cluster in 5.6.4. we're triying to configure access
to cluster through a Virtual IP address and both individual IP of each
cluster unit.[ul]the management subnet is 10.10.10.0/26the switch IP
which the 3 ports are connected (mgmt,p...
Hi All, i've recently setup a New site-to-site VPN Tunnel Tunnel Mode on
our 200D, in 5.4.Tunnel is Up and Running and i'm able to reach the
remote FW in https and remote Users are Able to reach Local
resources.but, but....Here is my issue :there is ...
Hi All,We have Several Fortigate Units on our infrastructure and we have
to make SIP traffic Works properly since few mounth.Actually, this is
not the first time we are face to this issue and we still stuck on
it.i've check several TIPS on Googleor w...
Hi ede_pfau thanks for your reply. it's true i forgot to mention vlan. i
already have this on my setup : "set lacp-mode active" there are 2 vlan
interfaces on the agregate, only one is OK. It's very strange :( Phi.
Hi Emnoc, i have a question please. in a ha Env, in your config
proposition : what 11.1.1.254 represent ( switch which mgmt is
connected?) or ? "config sys ha set ha-mgmt-status enable set
ha-mgmt-interface "mgmt" set ha-mgmt-interface-gateway 11.1.1...
HI All,After several Checks, I finally solved my issue.A first VPN
Tunnel (VPN_site1) was set up with An Any/Any phase 2 subnets ( Local
and remote)the second tunnel ( VPN_site2) was set up in first with the
same full permissive Phase 2 and then adju...
