Hello Community, I have an issue with achieving active connection to
FortiVoice located behind FortiGate Firewall using FortiFone, Below you
can see the diagnostic report from FortiFone, On FortiGate side, I
created two vip rules forwarding traffic ...
Hello community, I tried many ways to configure IPsec vpn to access only
a specific subnet, but all have failed.Can you guide to how to configure
such connection. Thank you!
Hello Fortinet Community I have an issue with traffic distribution, the
traffic is not distributed evenly between my wan interfaces. I came to
realize that the weight of member(2) is not 0 so that I can achieve
load-balancing between both interfaces....
Hello Community, I have an issue with my SD-WAN configuration maybe, the
traffic is being distributed unevenly between the two interfaces. I
tried all available options manual, best quality and lowest cost, non of
these options distributed my traffic...
Hello, Thank you it was useful for me; but now I have another problem,
1- FortiGate VM-64 v7.4.72- IPsec is up and I managed to access the
specified subnet and no other as needed, now I have another issue, since
I have a separate firewall policy for ...
Hello,1- FortiGate VM-64 v7.4.72- Yes, IPsec is up and I managed to
access the specified subnet as needed but now I have another issue,
since I have a separate firewall policy for the "specific address vpn"
that I have just created. When the policy i...
I check what you have sent me, but still the issue is occurringWhile
troubleshooting I realized that no route to port 3 available in the
routing table, but also sometime all traffic go through port 3
