Hello Experts, Confirmation for "Adaptive Forward Error Correction
(FEC)".https://docs.fortinet.com/document/fortigate/7.6.4/administration-guide/169010/adaptive-forward-error-correction?utm_source=chatgpt.com
Is Adaptive FEC only applied to the exis...
Hello Experts, At SD-WAN fortigate site-to-site VPN, we use IPsec
aggregation with 2 IPsec tunnels (WAN),which are connected to LTE. At
each LAN side, SIP phone is connected.As voice quality is not good
(maybe due to instablity of LTE),we added Forwa...
Hello Experts,I'm curious about addition/change of alias name for
interface at SD-WAN.Here is our situation. At SD-WAN, we use IPsec
aggregation called "AGG" which consists of WAN1 and WAN2At first, we
confirmed both SD-WAN and AGG were established.N...
Dear Experts, I want to know the theoretical overhead of bandwidth when
IPsec aggregation is used at SD-WAN.For example, pure WAN1: 5Mbps, pure
WAN2: 3Mbps and pure WAN3: 2Mbps.Total is 10Mbps. All WANs is
IPsec-aggregated as SD-WAN. PC1 -- FG1(IPsec...
Dear Experts, At SD-WAN configuration, when manual mode is used, is "set
priority-members" of "config service" stronger than "set priority" of
"config members"?I tried several values and it seems to be such
thing.Also, how should we use the both, inc...
Dear Jean-Philippe, Thanks for your detailed explanation. The same
parameters such as 'base/fec-base' and 'redundant/fec-redundant' are
configured in both "config vpn ipsec fec" and "config vpn ipsec
phase1-interface". Do we really need to configure ...
Dear Jean-Philippe, Thanks for your reply. set fec-mapping-profile
"FEC-Profile" What is "FEC-Profile"?It is new to me. Should I configure
somewhere?Can you tell me where/what/how to do? Thanks in advance and
best regards,
Dear Jean-Philippe, Thanks for you answer.I checked both egress and
ingress in IPsec configuration.However, it seems that FEC counter is not
increased, seeing result of "diag vpn tunnel fec VPN-NAME". Performance
SLA is configured and "Best quality" ...
Dear Princes and Experts, Any estimate overhead for payload 1000 byte
with the following configuration would be appreciated. fec-egress :
enablefec-send-timeout : 5fec-base : 10fec-codec : rsfec-redundant :
1fec-ingress : enablefec-receive-timeout : ...
