Hi, I need to connect Laptop with Linux to physical Forti with cable
console ( Connect with usb to Laptop )I connect cable console between
the Forti and Linux and I try to use with Minicom Command. I d'idnt
successWhen I running minicom and I stuck h...
Hello, I need to connect to my physical Forti with Linux Machine.I
connect cable console between the Forti and Linux and I try to use with
Minicom Command.I d'idnt successDoes anyone have an idea how to do it ?
Hi, I trying to do site to site between forti and checkpoint in my
home.I give to my forti Wan ip - 17.17.17.3 and to my CP - 17.17.17.222
( before Site2Site have a pint between them ).forti Lan -
172.16.3.0CheckPoint Lan - 172.16.0.0this is what I d...
emnoc wrote:Connect what to what? FWIW; In minicom you will probably
need to set the modem "/dev" to that device e.g /den/ttyusb01 You can
also run the minicom -s or even minicom -p /dev/ttys01 if you knew you
device type. You can also use screen in ...
ede_pfau wrote:From the cited KB article I deduct that you have to use
the WAN IP of the FGT in the CP's Quick Mode selector. If you use DES or
3DES doesn't matter much.Please reread the KB article again to
understand what they are doing. You'll see ...
ede_pfau wrote:I think I have finally found the reason for this.First,
have a look at this:
http://kb.fortinet.com/kb/viewContent.do?externalId=12091Although this
was written for FortiOS v3 it still applies.I think the CP will only
accept the remote'...
