Hi, Could we implement in Traffic Shaping in the firewall such that it
can detect and limit bandwidth usage of the WAN link based on the IP
address? Thanks. Thilina
Hi, I have a network with 192.168.1.0/24 subnet with an inside LAN
physical interface 192.168.1.7 connected to Fortigate 200B firewall.
There is a requirement to break the internal network into 2 subnets.
This means the internal network will contain ...
Does that mean if I have total WAN bandwidth of 20Mbps, I can create
policies and set limits for bandwidth usage based on IP addresses? Eg:-
For 20Mbps WAN bandwidth, 192.168.1.10 - Bandwidth limit of 10Mbps
192.168.1.15 - Bandwidth limit of 4Mbps et...
Thanks Ede for the reply. 1) This means it can keep internal networks
not visible to the firewall. We just need to create a static route and
allow traffic from the firewall policy. Creating a Vlan will remove the
need of creating a static route. 2) T...
Thank you for your swift response ShrewLWD. Really appreciated. I would
also like to know the following. 1) If we don' t create a firewall
interface for 10.0.0.0/16 network, and keep the network internal behind
a router, and create a policy to allow ...
