Hi I have an issue with change SSL to IPSec configuration.I follow
instruction to build FortiClient Dial UP
connection.https://community.fortinet.com/t5/FortiGate/Technical-Tip-FortiClient-Dialup-IPsec-VPN-Split-Tunneling/ta-p/192207I
have an issue w...
HiFortigate 60F, blocked after upgrade to release 7.4.9.i can't access
via https. Can someone help me to troubleshoot it?Message: Secure
Connection FailedAn error occurred during a connection to
172.16.1.1:11443. PR_CONNECT_RESET_ERRORError code:
PR_...
HiI have VM Forti Analyzer in private cloud.I set automatic backup to
public IP behind QNAP nas, specific port etc.FTP worksSFTP doesn't work,
have someone ever run this configuration? Thank youMarco
Hi Guys Scenario: FortiAnalyzer VM64 (Rel 7.4.1) in private cloud,
Fortigate(s) send logs via public IP Address to FortiAnalyzer IP
Address. Public IP Address listened on port TCP/UDP 514 I follow
Fortinet doc's. I authorized Fortigate on Fortianalyz...
HiI installed Forti-Analyzer VM64. When I attempt to login with: admin
and no password, the message is "Authentication failure. Please try
again..."When I registered virtual machine I set private IP address, is
it wrong? Does it need Public IP Addres...
HiI solved the issue, policy from DialUp-IPSec to tunnel IPSec mustn't
NAT the source IP.I can NAT traffic only from DialUP-IPSec to Internal
LANFrom remote Fortigate i can't see traffic because source ip adddress
was public ip of client.
Fortiget support assist me and write me that port 11443 is a port that
ike daemon is in listening instead ike-tcp port. I haven't fortigate in
release 7.6. Can someone test it?, if port 11443 is used about it?
Hi Billthis is the output of diag sys tctpsock | grep 11443
ike-TCP-port:config system settingsset h323-direct-model enableset
gui-local-in-policy enableset gui-dynamic-routing enableset gui-sslvpn
enableset ike-tcp-port 31443end
