Hello,On a FSW 148F, I plugged in my phone but although the port is up
and on the correct vlan, I cannot get it to receive an IP address. The
voice vlan is also on the port that connects through the other switch
connected to it, (Cisco trunk). My com...
Hi all,I configured out of the box a 148F layer 2 fortiswitch and
connected it to a Cisco 2960X layer 2 switch. From the Fortiswitch I can
ping anywhere in the LAN, but if connect my computer or IP phone to the
switch - nothing. The computer and phon...
This is my first time configuring a fortinet switch so, I really just
made the native vlan on the access port the same as the native vlan of
the data vlan I created.
Thank you for help on this. I didn't know that the native vlan on the
access port its self had to be the native vlan of the data vlan. I
didn't even know that access ports needed a native vlan on FSW. On Cisco
the native vlan is set on the trunk (Lin...
Your explanation was spot on< thank you. I have everything setup pretty
much just as you do, just different vlans.Cisco Trunk port:interface
GigabitEthernet1/0/24switchport trunk allowed vlan
1,15,16,501,995switchport trunk native vlan 995switchport ...
The Management interface is using the data vlan id and is also going
across the link aggregation port to the Cisco switch. I just noticed
from looking at your screenshot that I have nothing configured under the
port trunks settings, should I?
Correct, the FSW is last in line, connected (link aggregation\trunk) to
the Cisco switch. The link between the switches is configured to pass
the vlans and has the correct native vlan. On the Cisco side the allowed
vlans match. I can even ping (L3) t...
