Hi there, I' m using a Fortigate 110C with Firmware
v4.0,build0672,130904 (MR3 Patch 15). Now I have the problem that I can'
t see anything in the " Log&Report" section. In the Log and Archive
Statistics Widget on the Dashboard I can see everything b...
Hi, I have 2 address ranges: A 192.168.1.[1-10] and B 192.168.1.[30-60].
Now I made a Policy where I deny any traffic from A to B. Source
Interface: Internal Source Address: 192.168.1.[1-10] Destination
Interface: Internal Destination Address: 192.16...
Hi, I have a problem with a IPSEC VPN between 2 Fortigate Firewalls. On
one side I have a FG110C, on the other side a FG60C. The VPN was working
well until I made a firmware update on the FG110C form v3 MR1 to v4.0
(MR3) Patch 15. Now the VPN remains...
Hi to everybody, I' ve the following situation: There are about 10
AccessPoints with a static IP and the clients get their IP addresses
from the Fortigate device, which is acting as DHCP-Server. Everything is
in the same subnet. So far it works. Now ...
Hi to everybody! I need to allow the access to some users to the
internet but at the first connection I want to redirect them to a
certain website. I realized it already with a Firewall policy, setting
the option " Identity Based Policy" on enabled. ...
Livo you are the KING! the commands: config log memory setting set
status enable end and config log gui set log-device memory end are the
solution. Thanks alot for your perfect description. Maybe something
changed whlie I made some firmwareupgrades o...
Hi, I try to do this in " Firewall Objects" ->" Address" ->" Address" .
There I select the range and when I try to add the subnet, I get this
error.
Hi to everybody, so I found the solution and now I' m ashamed I just
reentered a new Pre-shared Key in Phase 1 on both sides and now it works
again... I hate those errors...spending extrem alot of time, disturbing
other people and then a solution lik...
Hi to everybody, thanks for the answers! I think first of all I' ll make
a Firmware Upgrade to check if this is the problem. Yes, I followed the
upgrade path on the 110C. The option " Enable perfect forward
secrecy(PFS)" is selected. In the event log...