My website is WordPress, added the Wordfence WAF and it shows only my
Firewall IP as the traffic hits. I am doing IP & port forwarding on the
firewall 60F. The following is my firewall policy and VIP: FG-60F
(IPS1-website) $ show config firewall vip ...
We have developed who uses a lot of bandwidth, so we need to move his
traffic to the other WAN (wan1) which is our backup ISP. how can we move
the Higher bandwidth usage user to WAN1? We are using Fortigate 60F with
firmaware v7.2.4 .
I have configured Virtual IP address from my website with port
forwarding"Interface: WAN1Static NAT typeLocal IP: 192.168.1.54Public
IP: XX.XXX.XXX.XXPort Forwarding External 80 Map to IPv4 Port 84The
Policy for this Virtual IP:-Incoming Interface: W...
This client has FG-224B, and it's at V4.0 MR2, and they have WAN2 for
the new ISP which provides 15MB speed (up/down). but at speedtest.net
the download speed is good, giving 15MB, but the upload is very bad
below 1MB. I have checked the firewall int...
I have replaced my Public IP with XXx and My mobile Data IP is
188.236.202.67. This is the sniffer log: diagnose sniffer packet any
"host 192.168.1.54 or host XX.XXX.XXX.XX" 4 FG-60F $ diagnose sniffer
packet any "host 192.168.1.54 or host XX.XXX.XXX...
I can get the user from he Fortiview sources, but cannot make a policy
for that.Do I need to make a policy or have to configure through the
traffic shaping?
I need to have fail-over along with load balancing, my main ISP we have
15MB, and the secondary ISP we have 8MB speed. I need to have
load-balancing when they are active, and fail-over when the Main is
down.
