Description This article describes how to fix an issue where, when one
of the devices in an HA cluster has additional VDOMs other than the
standard 10 VDOMs per firewall, the HA cluster does not form. Scope
FortiGate: model 3000 or higher (FortiGate-...
Description This article describes that the user's outgoing traffic
stops passing and is mostly unable to browse the internet when a traffic
shaper is configured with limited bandwidth allocated. Scope FortiGate.
Solution Run debug flow trace on the ...
Description This article describes how to encrypt logs before sending
them to a Syslog server. Scope FortiGate. Solution Use following CLI
commands: config log syslogd setting set status enable set mode reliable
end It is necessary to Import the CA c...
Description This article discusses when FortiGate Session Life Support
Protocol (FGSP) is enabled on FortiGate to sync sessions/IPsec tunnels
up with another FortiGate, the FortiGate does not support being the
initiator. It can only respond to IPsec ...
Yes you will have to upgrade it manually. You can find a list of the
latest versions on support.fortinet.com----> Firmware download--->
forticlient
yes that is wrong. Kindly create the static route with the sdwan zone.
Once you select interface under static routes. You should see an option
for the zone you placed both WAN links in(virtual-wan-link)
Hello @peacemaker Are you using the free version of forticlient or the
EMS licensed version of forticlient? If you are using the free version
of forticlient then that option is not available.
Did you create the default route for each WAN link separately or are
they both in the same zone(virtual-wan-link) as a default route? Kindly
check that