Hi, Because of "Troubleshooting Tip: Web pages not loading or taking too
long to load when a web filter is applied"I changed my HTTP, AND HTTPS
Policy's to proxy mode. The websites load fine, but if I turned on the
Antivirus scannig, it takes an extr...
Hi, (Fortigate 201F, 7.4.3)I have a new SD-WAN setting, and I have an
internal e-mail server. How can I limit the email server traffic (SMTP)
so that traffic only goes out through the designated SD-WAN interface.
If that interfece go down, I do not w...
HI, In a policy I turned on ssl deep inspection on HTTPS, LAN to WAN.In
the security events logs\ssl I found this BLOCK logs entries. Microsoft
address, what could be the problem? What is meant in event subtype:
unallowed-version? Thanks
Hi,I created a DENY policy (see. picture below). I tried to enable log
violation traffic, but after click OK, and than reedit the policy it is
switched off again. This is a normal behaviour?
Hello.I'm a bit confused about using application control in a firewall
policy in profile-based vdom.(Fortigate 81F, 7.4.3)I use the following
network design as an example:One LAN and one WAN interface, the DNS and
the ROUTING is set up and working. I...
Dear @pminarik ,Yes I now what was the KB about. For the last few days I
have been having problems loading web pages, when I came across this KB.
When I set the Kyber support to disable in Chrome or Edge on my
computer, the pages loaded with the orig...
I just got my second ISP line (wery fast but not guaranteed), and I'm
learning now how to use it. I've read quite a lot of documentation
(watched videos), and from these, it didn't make clear to me how SD-WAN
will work in practice. How SD-WAN rules a...
HI @atakannatak If I understand what you have written correctly, it is
not possible to solve what I want. The traffic will go out one way or
the other.I tested the SD-WAN rules and I see, e.g. for the following
rules, that after I disable the WAN-ISP...
