Technical Tip: How to configure an IP address on t...

jlim11 · 11-11-2024

Description This article describes why the OSPF neighborship is not forming when OSPF authentication is enabled and the interface is on PPPoE addressing mode. Key ID '1' is used for the OSPF authentication. However, The OSPF neighborship is not formi...

jlim11 · 10-23-2024

Description This article will explain why the FortiGate will only show a user is only part of a particular SAML group after authenticating and connecting to SSLVPN, even if the user is actually part of multiple SAML groups.For this example, the user ...

jlim11 · 10-22-2024

Description This article describes how to view the remote users connected to L2TP over IPSEC VPN. Scope FortiGate. Solution It is only possible to view the IPSEC VPN connection under the IPSEC Dashboard on the FortiGate. Even adding an XAuth column o...

jlim11 · 10-01-2024

Description This article describes how to configure an IP address on the IPSEC tunnel pointing to Azure which can be helpful when FortiGate needs to connect to a VM or resource hosted on Azure.The VPN tunnel is already up and working and other config...

jlim11 · 09-23-2024

Description This article demonstrates how to set up FortiClient IPSEC VPN access with LDAP as the authentication method. The IPSEC phase1 settings also selected for this example is IKE version 1, which is created with the IPSEC VPN Wizard as the defa...

User Statistics

User Activity

Troubleshooting Tip: FortiGate does not use the correct key ID configured for OSPF Authentication when the Interface is using PPPoE as addressing mode

Troubleshooting Tip: SSL VPN user only showing as part of one group while it is also part of other groups

Technical Tip: How to check connected L2TP VPN remote users

Technical Tip: How to configure an IP address on the IPSEC tunnel to Azure VPN

Technical Tip: Remote Access IPSEC VPN with LDAP authentication

Technical Tip: How to configure an IP address on t...

Technical Tip: Understanding the behavior of Forti...

KCS