Description This article describes how to fix the 40G interfaces of
FortiGate-1800F/1801F are down after the firmware upgrade to v7.2.8.
Scope FortiGate Solution Lab_FW1 # get system statusVersion:
FortiGate-1800F v7.2.8,build1639,240313 (GA.M)config...
Description This article describes how to fix the issue where Zoom and
Teams are missing from the Digital Experience Monitoring Dashboard.
Scope FortiSASE. Solution Zoom and Teams are missing from the Digital
Experience Monitoring Dashboard in the Fo...
Description This article describes how to resend FortiSASE Invitation
Code to multiple users. Scope FortiSASE. Solution FortiSASE Mature
version. Go to Configuration -> ACCESS -> Users and Groups, then select
Onboard Users. Select the users to whom t...
Description This article describes how to fix the VPN policy, as the
ZTNA tag is not working. Scope FortiGate, FortiClient EMS. Solution The
user cannot access any local resources or the internet after connecting
to the SSL VPN or dial-up IPsec VPN. ...
Description This article describes how to fix a dial-up IPsec VPN with
FortiToken fails to connect. Scope FortiGate, FortiAuthenticator.
Solution The user cannot connect to dial-up IPsec VPN with FortiToken
and encountered ‘FortiClient Wrong Credenti...
You may download the FortiClient 7.2 version from Fortinet support
portal (support.fortinet.com). Follow this KB
https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-download-different-or-old-versions-of/ta-p/285874
as a guide. Thank you.
Hi Amr_Ali, You can try the following which was mentioned in this
https://community.fortinet.com/t5/Support-Forum/Fortigate-ZTNA-Tag-added-in-policy-SSLVPN-cannot-access-local/td-p/208658
I have a functioning setup with the following: - one policy fr...
Hi Choll, Good day! Yes, that should work. It was mentioned on this KB
https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-add-or-replace-a-unit-in-High-Availability/ta-p/195585
as option 2. Just make sure the secondary FortiGate has the...
Hi Team, Good day! If the traffic over GRE tunnel stops working after
upgrading to 7.4.3, kindly run the command below three times. diag sys
gre list If the collisions of the GRE tunnel are increasing, then it
matches bug 987501. You may check this K...
Hi AEK, Good day! You need to configure the FortiSwitch manually to
migrate Cisco switch config. As FortiConverter doesn't support this
(https://docs.fortinet.com/document/forticonverter-service/23.1.0/online-help/765339/3rd-party-security-vendors-co...