Description This article describes how to configure FortiGate to comply
with PCI DSS 3.2. Scope FortiGate v6.0 and above. Solution To configure
FortiGate to comply with PCI DSS 3.2, change the multi-factor
authentication from optional to mandatory. c...
Description This article describes how to fix the GRE traffic stops
working after a firmware upgrade to v7.4.3. Scope FortiGate. Solution
The GRE traffic is working in v7.2.7. Then, it stops working after the
firmware upgrade to v7.4.3. If the collis...
Description This article describes how to fix the ZTNA not working when
using an IP pool. Scope FortiGate. Solution Below is a sample IP pool
configuration for full and Simple ZTNA policy. Full ZTNA policy: config
firewall proxy-policy edit 1 set uui...
Description This article describes why the user is not getting prompted
by authentication when accessing the server via SMB even if the user is
logged out. Scope FortiGate, FortiClient. Solution Diagram: In this
setup, the user is using SAML authenti...
Description This article describes how to fix the unable to log to
FortiMail GUI using SAML. Scope FortiAuthenticator. FortiMail. Solution
FortiMail – Service Provider (SP). FortiAuthenticator – Identity
Provider (IDP). Below is the error that says w...
Hi Team, Good day! If the traffic over GRE tunnel stops working after
upgrading to 7.4.3, kindly run the command below three times. diag sys
gre list If the collisions of the GRE tunnel are increasing, then it
matches bug 987501. You may check this K...
Hi AEK, Good day! You need to configure the FortiSwitch manually to
migrate Cisco switch config. As FortiConverter doesn't support this
(https://docs.fortinet.com/document/forticonverter-service/23.1.0/online-help/765339/3rd-party-security-vendors-co...
You may use the commands below to remove all the SD-WAN rules via CLI.
config system sdwan config service purge end end Make sure to backup the
FortiGate configuration first before performing this.Thank you.
You can use session-based. Then configure 60 on the weight value of the
25 Mbps ISP while 40 on the 15 Mbps ISP. 60 percent of the sessions will
go through the 25 Mbps ISP while 40 percent of sessions will go through
the 15 Mbps ISP. You may check th...
You may also check this BGP Resource List
https://community.fortinet.com/t5/FortiGate/Technical-Tip-FortiOS-BGP-Resource-List/ta-p/214290
and see if it helps.