You are leaving our website

edgar1 · 03-02-2023

Description This article describes How to test if ICAP is properly configured and responds. Scope FortiSandbox. Solution Execute telnet: telnet port used for ICAP is 1344 When the Telnet session opens, type the following and press Enter: OPTIONS ic...

edgar1 · 03-02-2023

Description This article describes that after renewing CA for certificate authentication, 'Error Certificate binding check failed' error appears when trying to authenticate via EAP-TLS (wireless or wired). rlm_eap_tls: Certificate binding check faile...

edgar1 · 03-02-2023

Description This article describes that after an upgrade from LENC to High Encrypt, the deep inspection does not work. It is possible to review using curl or OpenSSL that interchange certificate has 512 bits. subject=CN = www.globo.comissuer=C = US, ...

edgar1 · 03-02-2023

Description This article describes that the backup script is not working with the timestamp using automation-stitch. Scope Automation-stitch did not execute the backup and the timestamp properly: # config system automation-action edit "BACKUP" set ac...

edgar1 · 02-28-2017

Description This article describes the Sender verification failure which is an error that appears when trying to send an email. Details about the issue: 550-Callback setup failed while verifying yyy@domain.com550-Called: IP address MTA550-Sent: MAIL ...

User Statistics

User Activity

Technical Tip: How to test ICAP service

Troubleshooting Tip: Certificate Authentication error when renewing the CA for a remote user with EAP-TLS

Technical Tip: Unable to perform deep inspection after upgrade from LENC to High Encrypt

Technical Tip: Backup script is not working with the timestamp using automation-stitch

Technical Tip: Sender verify failed error

KCS

Fortinet Training Institute