Hi,FG-60e (6.0.4) in small home office build. Single wired subnet
(192.168.10.x) with tunneled FAP-24je connected on port 2 (FAP IP
x.10.12, tunneled SSID 10.95.0.x). From the wireless I am able to
connect, browse Internet, access resources on .10 su...
Hi all, OK, two sites, HQ and branch1. HQ has a static IP directly
connected to the FGT, branch1 has a dynamic IP and NAT router in front
of it. On one of the HQ subnets I have computers that need to access
both the Internet (via HQ DG) and 2 subnets...
Hi, Just started using the "Wi-Fi Controller" part of my FG-60C; goal is
to run several FortiAPs (221-B's) from this unit for network access and
rogue AP detection/suppression. In looking over what I've done so far, I
can see my test "rogue APs" but ...
Hi, OK, FG-60C, FOS v5.0,build0292 (GA Patch 9) in transparent mode (at
a remote location unfortunately). I asked the tech on site to enable
https administrative access on WAN1 so I could access the firewall for
maintennace (other security measures i...
Hi, A little confused at the moment - does v4 of the FortiOS (running on
a 60C) support SIP/TLS and SRTP? I have a new requirement to provide
these services to roaming managers, etc so looking for some insight -
passing traffic to an Asterisk server ...
Thanks for the reply - I had added a multicast policy but not sure that
is the issue. The printer is on the same wireless subnet as the iPhones
- is there still a requirement for a multicast policy? Thanks again for
the help...
Hey thank you for the information and it will probably be helpful
somewhere in the future. As far as this issue, I was able to work with
the ISP and convert the accounts to static IP addresses. I then went
back and set up normal site to side tunnels ...
Thanks again - when you say "dynamic" what exactly do you mean? Can you
provide an example config, screenshots, etc.? I'm familiar with the
"dynamic DNS" option but guessing that you are referring to something
else. Thanks again...been banging my hea...
