Hello everybody, i have a DS-lite cable-internet-connection and wanted
my FG60D LAN1 to autoconfigure with SLAAC from my Fritz!Box.I only have
two options at the LAN1: Manual and DHCP.When set to DHCP, i receive no
IPv6 Information at all.Where can i...
Hello, i bought a FortiGate 30D, but can not access it with the browser
(LAN4, standard setting). It works fine with Fortiexplorer and
HTTPS/HTTP is enabled.Is there some setting for access with the browser?
Regards
Hello, now that i successfully set up a Fortigate 60D together with some
FortiAP 210B, i need to create a Guest-WiFi with Captive Portal. My
problem is the creation of the Guest-Users, because this should be done
by the desk-clerk and i dont want him...
Hello, i have a Fortigate 60D (Firmware Version v5.0,build0271 (GA Patch
6)) and a FortiAP 210B, which are both connected to the same Subnet. The
AP is configured with fixed IP and i can access it on HTTP, but it
doesn' t get discovered by the 60D. W...
emnoc wrote:It's probably a bug, what I would do if you had the time and
up for a challenge, 1: enable multi-vdom support2: build a vdom name
"whatever you want"3: pick one interface, enable it for ipv6
advertisement & with a ipv6 address /64 and the...
Now i set up a static IPv6 address and that worked as expected. But
autoconf and DHCP still remain silent, even after resetting the device
to factory default, setting up IPv6 and rebooting.
I tried all ports by now. And yes, the other clients are all SLAAC
(tested with raspbian and debian without dhcpcd5). Anyway, even if the
Fritz!Box where offering DHCPv6 in addition to RA, then it would be
supposed to work too.
emnoc wrote:You need to relook it's under config ipv6 set ip6-mode You
probable need to unset that value and than SLAAC will be enabledI just
unset it, but that didn't help. No IPv6-address... For those who might
ask - yes, other clients receive IPv6...
