Hi I have some issues when i add subnets to an existing vpn tunnel. For
example i have in phase2 address groups with only one source and one
destionation subnet. Tunnel is up and running with these and the i add
on both side another subnet. I can see...
hi i am trying to get the proxy arp feature to work, so for i have two
fortigates directly connected via wan1 and both firewalls have a server
connected to the internal interface. FGT1 Internal: 192.168.1.99/24
Server1: 192.168.1.15 WAN 192.168.140.2...
Hi I need to monitor ipsec tunnels on a 50B (FortiOS 4MR2.6) using
Nagios but i cannot find the right OID. According to the 4MR2 System
Administration manual you can check for example the serialnumber of the
device using this OID with snmpget: staff@...
Yes that is a good suggestion and would probably work well. I have seen
this issue on vpn tunnels with FGT in one end and Cisco ASA in the other
end, that time i had three subnets and the Cisco used only two no matter
what, and it was random so it ma...
A function so when adding a firewall policy another policy with the
opposite interfaces and addresses can be created. This could be useful
to save time when configuring interface based vpn. So if i create a
policy going from internal to vpn tunnel in...
What version are you running ? I have noticed that it sometimes help to
change sslvpn port to something else and the back. Think it restarts the
sslvpn daemon.