I've this issue with one of my units in that it will randomly lose
routes for some VOIP phones. Some context: Site A (main) - VOIP
controller existsSite B (remote) - VOIP phones need to connect via IPSEC
tunnel to Site A controller (static IP). Site ...
Is it possible to backup the config of a Fortigate using Fortimanager? I
can view the entire database config, but there's no way to download it.
Be a lot easier for me if I could do it through Fortimanager versus
logging into 30 units to pull it down...
I'll try to keep this as clear as possible, but I need help getting
SSLVPN traffic to route correctly to my remote sites accessed via IPSec.
I can get into my home site (Site A) just fine, but any traffic past
that never makes it. I've setup static r...
This has been really confusing me the past several days. I have IPSEC
tunnels setup between my units and those work fine. If I use a device
connected behind a subnet on device 'a' I can get to subnet 'b'.
Therefore the VPN component is working. Howev...
I can't find anything on this by searching, but is it possible for
another Fortigate to pull down DNS records from a master DNS database on
another Fortigate? Basically I have a 300c running a master DNS database
(this works fine, resolves as intende...
Paul S wrote:Rn34 wrote: My 100d's are running 5.2.3 (dunno what they
upgraded from, probably in the 5.0 range) but the upgrade went fine and
they run 5.2.3 just fine. I've not had any specific bugs with 5.2.3 on
them that I know about. do you get UT...
Baptiste wrote:Hello, I'm running 100D on 5.2.2, I saw on release notes
that upgrade to 5.2.5 is only support from 5.2.3.My question : is
upgrade to 5.2.3 buggy ? or I can safely upgrade to 5.2.3 and then to
5.2.5 ? My 100d's are running 5.2.3 (dunno...
vjoshi wrote:Hello, - IPSec VPN does not allow you the IP addresses
which are not part of the phase2 quick mode selectors - In SSL-VPN (web
mode), the user traffic reaches the destination with source as internal
interface. Destination server(resource...
emnoc wrote:However logs are not being transmitted from the unit up to
the manager even though there is a valid tunnel. Have you looked at the
"set source-ip x.x.x.x" option in the config syslogd settings? You can
specify the source and in your case ...
