A couple of questions regarding VLANs and the necessary policies to
reach other VLANs and the internet. Scenario: I have a couple of ports
on our FortiGate set up as a hardware switch (LAN). I have a single
static route set up (0.0.0.0/0 to ISP) and ...
New to Fortigate/firewalls. Have a 200D, firmware v 6.0.11. Can view and
edit default web filter settings, but cannot apply default web filter to
a policy. The only web filter that I can apply (out of 5 filters) is
monitor-all. Thoughts?
This is a very helpful response, @Toshi_Esumi . Thank you. I did have
NAT setup for outbound traffic. That much I got right. I assumed that
you had to have a policy that allowed traffic back in (to establish and
maintain sessions), but it makes sense...
So question 1 is resolved. I viewed the documentation and in an example
for VLAN configuration you are told to create policies for the VLANs to
reach the internet. So I created 2 policies: VLAN to WAN and WAN to
VLAN. We have internet.Virtual VLAN sw...
Yeah, I tried accessing it through different browsers. Same in all; no
dice. I have 8x5 support. I'll have to give in and call them on Monday.
I'll post the resolution later.